Use - Vermeiren LiNX 200 Manual De Instrucciones

OPERATOR CONTROL LiNX 200

1. Use

The operator control built into your electric wheelchair enables you to control all the driving, steering,
braking and operating processes and to control other adjusting motors (lifting column, seat and back
adjuster). The wheelchair's electrical unit and electronics are constantly being monitored internally.
Any fault in the electronics is indicated on the status indicator (1) (see the chapter on troubleshooting).
Vermeiren is responsible for the changes in the software. For changes in the software contact
Vermeiren.
L
WARNING:
Risk of burns – Be aware that the surface of the operator control can
potentially get hot when it is exposed to strong sunlight for long periods.
1 = "ON / OFF" button,Status indicator
2 = Battery charge indicator
3 = Speed switch: left-slower; right-faster
4 = "Horn" button
5 = Joystick
6 = Drive funtion
7 = Adjusting function selector
8 = Drive/actuator status
9 = Hazard lights and left indicator
10 = Driving lights and right indicator
11 = Software installation
12 = Charger connector
Without lightning
L
Note that, when pressing the "ON/OFF" button, the joystick stays in the central position for at
least five seconds. It is programmed this way for technical and safety reasons, to prevent the
joystick being pushed at the same time as the wheelchair is being switched on. If both
processes are activated at the same time, the steering unit locks itself and can only become
operational again after being switched off completely.
You can sound an acoustic warning signal with the "Horn" (4) button.
To activate the adjust functions, press button (7) upwards/downwards until the corresponding function
is shown on the drive/actuator status (8).
Press and hold the "Left indicator" (9) or "Right indicator" (10) buttons to signal a change in your
driving direction. The driving lights are switched on or off by short pressing the "Lights" (10) button.
Press the "ON/OFF" button (1).
The charge indicator (2), which
also indicates the batteries'
charge level, lights up for a
moment. If all the lights come on,
the batteries are sufficiently
charged. If the lights do not all
come on, you must adjust your
driving activities to suit the low
capacity of the batteries. If the
battery charger display lights do
not come on, check the plug
connections of the electronic
system.
Now select the driving program
you want by turning the speed
switch (3), left turn to go slower
and right turn to go faster.
Select the drive function with the
drive function button (6).
To set the wheelchair in motion,
push the joystick (5), forwards
slowly. The speed will increase
when you push the joystick
further forwards.
If you want to turn left or right,
simply push the joystick in the
With lightning
desired direction. To reverse, pull
the joystick backwards from the
central position.
2
LiNX 200
vA - 2016-09