Roberts SUPER SIX 10-46 Manual De Operación página 3

GENERAL SAFETY RULES CONTINUED
MAINTENANCE:
1. Clean out accumulated dust.
2. Check the brushes periodically for wear and replace both brushes when either is worn to
about 1/3 in length.
DO NOT MAKE ANY ADJUSTMENT WHILE THE MOTOR IS IN MOTION!
WARNING:
KEEP SAFETY GUARDS IN PLACE TO AVOID POSSIBLE SERIOUS INJURY!
Never cover, nor allow dust to accumulate in air vents since they must always be open for
proper motor cooling.
Always remove the electric cord from the power supply before changing brushes, lubricating
or when working on the unit, to avoid possible serious injury.
To assure safety and reliability all repairs with the exception of external accessible brushes
should be performed by an Authorized Service Center or other qualified
Service Organization.
PRODUCT SPECIFIC SAFETY WARNINGS
1. The Roberts 10-46 SUPER SIX Jamb Saw is manufactured for the specific use of trimming
wood door jambs and base molding by professional flooring installation craftsmen only! It
can cause bodily harm if used improperly or if operated by inexperienced persons.
2. Do not use this product for any purpose other than stated in these instructions.
3. Never operate this saw "freehand".
4. Always wear eye protection and gloves. It is recommended that safety goggles which are
fully enclosed and contact your forehead and cheeks be worn to prevent injury. Do not wear
loose clothing. Dust masks are recommended.
5. Unplug the Roberts 10-46 SUPER SIX 6" Jamb Saw when not in use. Store it in the custom
molded case.
6. Keep blade safety guards installed at all times.
7. Avoid hitting nails, screws, masonry, tile or other hard materials. Keep work area clear of
tools and scraps.
a. These materials can cause dangerous chips and debris to be ejected from the saw.
b. The blade will be damaged or dulled. Teeth can be broken or bent, requiring
replacement of the blade.
c. Check jambs and base moldings carefully to locate nails or other fasteners so they can
be removed or avoided during trimming.
8. Do not use this or any electric tool on wet floors or near standing water.
9. Make sure blade retaining nut and handle retaining nuts are tightened securely
before operating.
10. Do not use masonry or diamond blades in this saw. Cutting tile, bricks, or masonry creates
abrasive dust, which can damage the gears and ball bearings. Product warranty is VOID if
the Roberts 10-46 SUPER SIX 6" Jamb Saw is used to cut masonry.
After use, check tool to keep it in top condition.