Tabla de contenido
CLLLUKE700RGB / CLLLUKE1000RGB System Settings - terms and explanations
Display
Master
Laser
Default
Test Pattern
CLLLUKE400RGY System Settings menu
Setup
ENTER -> UP/DOWN
22
ON
= Display light is permanently on
OFF
= Display light is permanently off
5S
= Display light turns off after 5 seconds of inactivity
15S
= Display light turns off after 15 seconds of inactivity
ON
= Master/Slave mode: DMX signals will be output
OFF
= Master/Slave mode: DMX signals will not be output
Size 10 - 128
= Setting the maximum size of the laser projection
Colour
= RGB = entire colour spectrum. RGY = red, green and yellow.
InvertX ON
= Movement direction of the X-axis is reversed
InvertX OFF
= Standard movement direction of the X-axis
InvertY ON
= Movement direction of the Y-axis is reversed
InvertY OFF
= Standard movement direction of the Y-axis
= Reset to factory setting
= Test projection and setting the speed of stepper motors
Display
ENTER -> UP/DOWN
Master
ENTER -> UP/DOWN
Laser
ENTER -> UP/DOWN
Default
ENTER
Test Pattern
ENTER -> UP/DOWN
Note on the master/slave mode: Master unit: Master ON
from 10Kpps to 30Kpps (Kilo points per second)
ON
OFF
5S
15S
ON
OFF
Size
InvertX
InvertY
Scanner 10 - 30KPPS
Slave unit: 4-CH Mode
ENTER -> UP/DOWN
ENTER -> UP/DOWN
ENTER -> UP/DOWN
Size 10 - 128
ON
OFF
ON
OFF
Tabla de contenido
