Mx Onda MX-AS2058 Manual De Instrucciones página 70

Then separate the particle filter + HEPA filter assembly from the cyclone
filter, following figure:
Wash the reservoir, the cyclone filter, the particulate filter and the HEPA
filter with plenty of water. Never use abrasive products or solvents. Then
dry the tank and the cyclone filter with a dry cloth. The particulate filter as
well as the HEPA filter must be left to dry on their own, do not use a hair
dryer or heater as it will damage the filters.
Once the tank and filters are clean and completely dry, place them as
described below:
a. Close the bottom lid of the tank, a "click" will indicate that it is properly
closed.
b. Insert the cyclone filter inside the tank.
Note: The cyclone filter has a position, which is determined by two tabs
of different sizes, to place the tank in the correct position.
c. Insert the particulate filter into the HEPA filter holder.
d. Place the particle filter + HEPA filter assembly inside the cyclone filter.
e. and. The reservoir has a flange on the side opposite the suction inlet
(square hole). To attach the tank to the main body of the vacuum
cleaner, you must insert the tab of the tank into the hole of the support
of the main body of the vacuum cleaner (step 1), then push the tank
towards the main body of the vacuum cleaner until you hear a "click"
(step 2) that it will be the indication that the tank is correctly coupled.
2
1
10