Technical Data; Before Starting The Equipment - EINHELL Expert TE-AG 230 Manual De Instrucciones Original

Anleitung_TE_AG_230_180_SPK8__ 07.08.12 08:38 Seite 28
GB

5. Technical data

Mains voltage:
Power input:
Idling speed:
Max. wheel diameter:
Mounting spindle thread:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Surface sanding/grinding
Vibration emission value a
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
28
230 V ~ 50 Hz
2300 W
8000 rpm
180 mm
M14
I
5.8 kg
100 dB(A)
3 dB
111 dB(A)
3 dB
= 9.802 m/s 2
hAG
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.

6. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6.1 Fitting the additional handle (Fig. 2)
The angle grinder must not be used without the n
additional handle (4).
The additional handle can be secured in any of
n
three positions (A, B, C).
Tool side
Left (position A / as shown)
Right (position B)
Top (position C)
6.2 Setting the guard (Fig. 3)
Switch off the tool. Pull the power plug.
n
Adjust the guard (5) to protect your hands so that
n
the material being ground is directed away from
your body.
The position of the guard (5) can be adjusted to
n
any specific working conditions. Undo the clamp
handle (a) and turn the cover (5) into the
required position.
Ensure that the guard (5) correctly covers the
n
gear wheel casing.
Secure the clamp handle (a) again.
n
Ensure that the guard (5) is secure.
n
Take care that the safety device is secure.
Never use the angle grinder without the
guard.
Suitable for
Right-handed users
Left-handed users
Using cutting wheels