Water And Ice Dispensers - Thermador KBUIT4250A Manual De Uso

After replacing the water filter, press RESET and hold for
2 seconds to change the water filter display to 99 percent.
Lights Off Feature
Your refrigerator is equipped with a lights off feature that allows
you to turn off all of the interior lights.
To turn off the interior lights, press and hold the water filter
RESET and the °C SELECT buttons simultaneously until the
internal lights turn off. To turn the interior lights on, press and
hold the water filter RESET button and the °C SELECT button
until the interior lights turn on.
NOTE: This feature does not turn the refrigerator off. The
refrigerator will continue to operate normally while the lights are
off.
Wa t e r a n d I c e D i s p e n s e r s
( o n s o m e m o de l s)
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Failure to do so can result in cuts.
You may have one or more of the following options: the ability to
select either crushed or cubed ice, a special light that turns on
when you use the dispenser, or a lock option to avoid accidental
dispensing.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer. When
the dispenser lever is pressed:
A trap door opens in a chute between the dispenser and the
ice bin. Ice moves from the bin and falls through the chute.
When you release the dispenser lever, the trap door closes
and the ice dispensing stops. The dispensing system will not
operate when the freezer door is open.
To dispense ice:
1. Press button for the desired type of ice.
For cubed ice, press the CUBES button.
For crushed ice, press the CRUSHED button.
NOTE: For crushed ice, cubes are crushed before being
dispensed. This may cause a slight delay when
dispensing crushed ice. Noise from the ice crusher is
normal, and pieces of ice may vary in size. When
changing from Crushed to Cubes, a few ounces of
crushed ice will be dispensed along with the first cubes.
2. Press a sturdy glass against the ice dispenser lever. Hold the
glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the lever in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: The first few batches of ice may have an off-flavor
from new plumbing and parts. Throw the ice away. Also, take
large amounts of ice from the ice bin, not through the
dispenser.
The Water Dispenser
If you did not flush the water system when the refrigerator was
first installed, press the water dispenser lever with a glass or jar
until you draw and discard 2 to 3 gal. (8 to 12 L) or approximately
6 to 7 minutes of water after water begins dispensing. It will take
3 to 4 minutes for the water to begin dispensing. The water you
draw and discard cleans the system and helps clear air from the
lines. Allow several hours for the refrigerator to cool down and
chill water.
To dispense water:
1. Press a glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to maintain a fresh
supply.
IMPORTANT: Depending on your model, the small removable
tray at the bottom of the dispenser is designed to catch small
spills and allow for easy cleaning. There is no drain in the tray.
The tray can be removed from the dispenser and carried to the
sink to be emptied or cleaned.
7