Blaupunkt BP109 Manual Del Usuario página 9

Electrical Tools – General Safety Guidelines
These are still relevant if you have purchased a battery tool and it is supplied with a battery charger.
• Use an RCD: For safe operation it is always necessary to use and RCD device which will protect you in the case of an electrical
emergency.
• Operating voltage: Before putting the tool into operation, make sure that the voltage stated on the rating plate is the same
as that of your electricity supply.
• Extension cables: Always ensure a cable is does not become a trip hazard by routing it safely to your work location. Do not
walk, ride or place objects on the cable as it will result in damage. It is important that you are aware of the location of an
extension cable whenever you are working to prevent accidents. Always protect power cables from sharp edges, heat and oil.
Do not allow the cable to become knotted or kinked.
• If the extension cord becomes damaged: Pull the plug immediately from the socket outlet, do not touch the cable until you
have done so.
Battery Tools – General Safety Guidelines
These guidelines are relevant for all tools supplied with a battery.
• Battery Acid Hazard: If accidental damage occurs to the battery or it is used under abusive conditions, liquid may be ejected
from the battery; avoid contact. Liquid ejected from the battery may cause irritation or burns.
• If Contact Occurs, quickly flush with water. If liquid contacts eyes flush with water for a minimum of 10 minutes and seek
medical help. Inform the medical staff that the liquid is a 25-35% solution of potassium hydroxide.
• Connecting A Battery: Before connecting a battery to a power tool always ensure that the on/off switch is locked in the off
position. Unintentional activation of the tool may result in serious personal injury.
• Transporting The Tool: Always remove the battery before transporting the tool when transporting the tool to avoid uninten-
tional activation.
• Charger: Recharge only with the charger specified by the BLAUPUNKT. A charger that is suitable for one type of battery pack
may create a risk of fire when used with another battery pack.
• Correct Battery: Use BLAUPUNKT power tools only with BLAUPUNKT battery packs. Use of any other battery packs may create
a risk of injury and fire.
• Short Circuit Hazard: When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals
together may cause burns or a fire.
• Do Not Open: Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks open
or cracks, immediately discontinue its use and do not recharge it.
• Disposal: When the battery reaches the end of it's life or is disposed of for any other reason, it must not be disposed of in
household waste. In order to protect the environment please take to your local waste recycling centre or other authorised
collection and disposal facility.
Battery Tools – Charging The Battery
The following guidelines will ensure the lifetime of the battery and charger is not reduced.
• Charge Before Use: The battery pack for this tool has been shipped in a low charge condition. You should charge the battery
pack fully before use.
• Charge Cycles: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.
• Indicator Lights: The red LED on the front right hand side of the charger will illuminate to indicate charging is in progress. A
green LED will illuminate when the battery is fully charged. If at any point during the charging process none of the LEDs are
lit, remove the battery pack from the charger to avoid damaging the product. DO NOT insert another battery.
• Overcharging: Once the battery is charged and the green light is illuminated remove the battery immediately.
• Temperature: Do not charge batteries when the work area or the battery temperature is at or below 0° C or above 45° C.
• Charger Care: When charging more than one battery pack in succession allow at least 30 minutes for the charger to cool
down before charging an additional battery.