ANSMANN 130Q Manual Del Usuario página 6

USE
CHARGING DEVICES
In order to charge a device, such as a smartphone for example, please
use a suitable USB QC3.0 cable or the original charge cable for your
device. The USB QC3.0 charger has a USB-A output. Please use a sui-
table cable for this. Insert the USB plug of the cable into the USB QC3.0
charger and the other end into your device. The charging process
starts automatically.
The USB QC3.0 charger has both USB and Qualcomm QC3.0 protocols.
In order to be able to use this technology, please check that your
end-device is compatible.
Simultaneous charging of multiple end-devices is possible with
restrictions. This is dependent on the total required charge current
and charge voltage.
The USB QC3.0 charger switches off automatically once the charging is
complete. Please disconnect your device from the USB QC3.0 charger
once the charging process is complete.
The USB QC3.0 charger may heat up a little depending on the output
power required.
USE
NOTE: MAINS VOLTAGE 110-240V
The USB QC3.0 charger is suitable for a mains voltage of 100-240V
and so can be used throughout the world. Please note that a suitable
country-specific adapter may be required for this.
NOTE
Automatic detection: No manual adjustments or changes re-
ƒ
quired - only the correct components are required (cable and
end-device must be QC3.0-compatible).
With the huge number of different QC3.0 end-devices and their
ƒ
software/ firmware versions, it is possible that the function is
not detected or that it is not fully or flawlessly supported.
End-devices whose original chargers require more than 18W of
ƒ
rated output power will charge slower with this charger.
Deutsch |
Svenska | Italiano | Nederlands | Suomi | Norsk | Dansk
English | Français | Español | Português