Blade Attachment - Hinkley 52 PROPEL ILLUMINATED Manual De Instrucciones

BLADE ATTACHMENT

Place fiber washer on screw. Insert this assembly through
1
the blade and start the screw into the blade arm. Repeat
this procedure without tightening the screw until all 3
screws have been started into the blade arm (Fig. 1).
Tighten each screw starting with center screw.
2
Fasten blade assembly to motor with provided screws and
3
lock lockwashers. Repeat procedure for remaining blades
(Fig. 2). Make sure screws are TIGHT! Loose motor screws
can contribute to unnecessary hum during operation.
NOTE
Cordless power screwdrivers are
they usually strip the heads of the screws and usually will not
fully compress the lock washers on the motor screws. Use a
large flat blade screwdriver for final tightening to fully
compress the washers. This will help ensure proper
alignment of the blades and noise-free, wobble-free running.
NOT recommended, as
Screw
Fiber Washer
Blade Arm
Fig. 1
Screws
Blades Assembly
Fig. 2
©2019 Hinkley Lighting, Inc.
Blade
11
| hinkley.com