Operating Instructions - Kobalt 0300841 Manual Del Usuario

OPERATING INSTRUCTIONS

1. Preparing for Startup
WARNING: Risk of bursting. Too much air
pressure causes a hazardous risk of bursting. Check the
manufacturer's maximum pressure rating for air tools and
accessories. The regulator outlet pressure must never
exceed the maximum pressure rating
a. Set the ON/OFF switch (I) to the O (off) position.
b. Turn the air pressure regulator knob (D) counter
clockwise until it stops.
c. Attach air hose/accessories or air tools (not
included) to the quick coupler (F).
2. Starting up the Compressor
WARNING: High temperatures are generated by
the electric motor and the pump. To prevent burns or
other injuries, DO NOT touch the compressor while it
is running. Allow it to cool before handling or servicing.
Keep children away from the compressor at all times.
WARNING: When adjusting from a higher to a lower pressure, turn the knob
counterclockwise past the desired setting. Then turn clockwise to reach the desired pressure.
Do not exceed operating pressure of the tool or accessory being used.
a. Close the tank drain valve (G) by turning clockwise.
b. Plug in the power cord (J).
c. Set the ON/OFF switch (I) to the I (on) position and allow tank pressure to build. Motor
will stop when tank pressure reaches "cut-out" pressure.
d. Turn the air pressure regulator knob (D) clockwise until desired pressure is reached.
e. The compressor is ready for use.
3. Shutting Down the Compressor
WARNING: To avoid personal injury, always shut off and unplug the unit, and relieve all air
pressure from the system before performing any service on the air compressor.
WARNING: Risk of unsafe operation. The unit cycles automatically when power is on. When
performing maintenance, you may be exposed to voltage sources, compressed air or moving parts.
Personal injuries can occur. Before performing any maintenance or repair, disconnect the power
source from the compressor and bleed off all air pressure.
CAUTION: Escaping air and moisture can propel debris that may cause eye injury. Wear
safety goggles when opening the drain valve.
a. Set the ON/OFF switch (I) to the O (off) position.
b. Unplug the power cord (J).
c. Reduce the pressure in the tank through the outlet hose. Pulling the pressure relief valve
ring (H) and keeping it open will also reduce the pressure in the tank.
d. Tip the compressor so the tank drain valve is at the bottom of the tank. Then open the
tank drain valve counterclockwise to allow moisture to drain from the tank.
H
F
J
8
I
D
ON
OFF
CLOSE
OPEN
G