Gira 5448 02 Manual De Instrucciones página 9

Actuador inalámbrico de conmutación de 1 elemento, conector intermedio
Deactivate sun protection swit-
ching state
Priority, twilight
Activate twilight switching sta-
te
Deactivate twilight switching
state
Switch off brightness overs-
hoot
Switch on brightness unders-
hoot
Invert switching output
Minimum switching repeat ti-
me
Information window
During channel selection in the Information window, the following settings can be made or va-
lues displayed.
32592212 10864992
On, Off
Basic setting: Off
0...4
Basic setting: 0
On, Off
Basic setting: On
On, Off
Basic setting: Off
On, Off
Basic setting: On
On, Off
Basic setting: Off
On, Off
Basic setting: Off
100 ms ... 10 sec
Basic setting: 100 ms
24.03.2017
Defines the behaviour of the
output on deactivating the sun
protection. Only visible when
the priority for the sun protec-
tion is 0.
Specifies the priority for reca-
lling and removing a scene of
type Twilight for the channel.
Defines the behaviour of the
output on activating the twilig-
ht function.
Defines the behaviour of the
output on deactivating the twi-
light function. Only visible
when the priority for the twilig-
ht function is 0.
Allows automatic switch-off
according to the brightness. If
the parameter is On, then the
light controller switches off au-
tomatically when the bright-
ness setpoint is greatly excee-
ded. This parameter is not yet
active, as a light controller has
not yet been implemented.
Allows automatic switch-on
according to the brightness. If
the parameter is On, then the
light controller switches on au-
tomatically when the bright-
ness setpoint is greatly un-
dershot. We recommend only
using the parameter in con-
nection with the parameter
"Switch-off on brightness
overshoot". This parameter is
not yet active, as a light con-
troller has not yet been imple-
mented.
Inverts the switching output
from NO contact function (fac-
tory setting) to NC contact
function
Limits the switching speed of
the device by increasing the
value, in order to protect the
load, for example. Only when
the set time has elapsed is
switching possible again. The
last command during the bloc-
king time is executed after a
delay. The switching repeat ti-
me starts after each switching
operation.
9/10