Step 4 - Make Water Connection - Haier HRT18RCW Manual Del Usuario

8. Repeat steps 1-5 to install the handle to the other door.
9. With both handles mounted, align the handles.
10. Slowly open the door, and then completely tighten the
screws.
11. For stainless steel handles, use the hex key provided
and then tighten an additional half turn.
STEP 4 - MAKE WATER
CONNECTION
IMPORTANT:
This water supply installation is not covered under
warranty by the refrigerator or ice maker manufacturer(s).
Follow these instructions carefully to minimize the risk of
expensive water damage.
Do not install water tubing in locations where the
temperature falls below freezing.
1. Unplug refrigerator or disconnect power.
3. Remove rear access cover for the compressor
compartment.
4. Connect copper water supply line to the household water
system.
5. Using a compression nut and ferrule, connect the water
supply line to the ice maker inlet valve.
6. Turn ON water supply and tighten any connections that
leak.
7. Reinstall rear access cover for compressor compartment.
8. Coil excess water supply line behind refrigerator, as
shown. Arrange coils so they do not vibrate or wear
against other surfaces.
NOTE: Using the water line clamp (provided) and #8
screw (provided), secure the water supply line to the back
of the refrigerator.
A - #8 Screw
B - Water Line Clamp
7
A
B