Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
protect the lamp from abrasion and scratches. Do not install or use cracked or broken lamps. In case a
lamp cracks or breaks, disconnect from power supply, allow the unit to cool and remove/replace the
broken lamp
•
never touch the lamp bulb with bare hands. Oil and grease can contaminate the quartz surface and
reduce the lamp performance and life
•
do not remove the plastic protection around the lamp until after having installed the lamp
•
open the top sliding cover by turning (anti‐clockwise) the ¼ turn fastener. A tool, such as a screwdriver or
a coin will be needed. Slide the cover open to have full access to the lamphouse.
•
insert the lamp in the lamp holder. MAKE SURE THE LAMP IS CORRECTLY POSITIONED AND PERFECTLY
VERTICAL.
•
carefully close the top sliding cover by turning (clockwise) the ¼ turn fastener
7. INSTALLATION
This product is fitted with a suspension stirrup rotating around the body of the product, thus allowing the
product to be installed suspending or standing. The stirrup is fitted with a Ø12mm clear hole for the
attachment of a hook clamp or a stand pivot.
Before installing this product make sure the structure you are fixing the product to can withstand its load
and the total load of any other unit installed.
1. Hang the unit to the structure and firmly tighten the clamp.
2. Fix the safety bond
8. CONNECT TO THE POWER SUPPLY
•
Make sure the plug you are fitting withstands the lamp power load.
•
This fixture must be grounded
•
To perform a correct wiring, please note that the cores in this mains lead are colour‐coded as follows:
In case the colours of the cores do not correspond to the colour of the connection points on your plug,
please proceed as follows:
•
The green or green and yellow core must be connected to the connection point marked
with the letter E or with the symbol
•
The blue core must be connected to the connection point marked with the letter N or with
the symbol
•
The brown core must be connected to the connection point marked with the letter L or
with the symbol
•
Before you finally position this product for use, temporarily connect it to a properly fused power supply
to check the lamp works correctly.
•
Protect each product with a fuse suitable to the lamp you are using. Should you connect this product to
a dimmer pack, please make sure this is fitted with suitable protective fuses.
9. CLEANING AND MAINTENANCE
To ensure maximum performance of the product, a regular maintenance service should be carried out.
Please make sure the product is cold and disconnected from power supply when doing this.
•
clean all reflective parts such as reflector, mirror and lens opening the product, if necessary.
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email [email protected] – web www.ldr.it
LDR Aria f1000 & Aria pc1000 User's Manual – 1.0
Ground: green+yellow – Neutral: blue ‐ Live: brown
or coloured in black
or coloured in red
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
or coloured in green or in green‐yellow
4
Tabla de contenido
