DeWalt DW976 Manual De Instrucciones página 24

E N G L I S H
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
2
1 mm ; the maximum length is 30 m.
Assembly and adjustment
• Prior to assembly and adjustment,
always remove the battery pack.
• Always switch off the tool before
inserting or removing the battery pack.
• Use only D
chargers.
Battery pack (fig. A)
Charging the battery pack
When charging the battery pack for the first time, or
after prolonged storage, it will only accept an 80%
charge. After several charge and discharge cycles,
the battery pack will attain full capacity. Always check
the mains prior to charging the battery pack. If the
mains is functioning but the battery pack does not
charge, take your charger to an authorised D
repair agent. Whilst charging, the charger and the
battery pack may become warm to touch. This is a
normal condition and does not indicate a problem.
Do not charge the battery pack at
ambient temperatures <4 °C or >40 °C.
en - 5
WALT battery packs and
E
E
• To charge the battery pack (8), insert it into the
charger (10) as shown and plug in the charger.
Be sure that the battery pack is fully seated in the
charger. The red charging indicator (11) will blink.
After approx. 1 hour, it will stop blinking and
remain on. The battery pack is now fully charged.
The battery pack can be removed at any time or
left in the connected charger indefinitely.
Inserting and removing the battery pack
• Insert the battery pack into the pistol grip (7)
until it clicks in place.
. • To remove the battery pack, press the two
release buttons (9) simultaneously and pull the
pack out of the pistol grip (7).
Inserting and removing bits (fig. A & B)
Your drill is equipped with a bit holder (6).
• Open the chuck by turning the sleeve (12)
counterclockwise and insert the bit shank.
• Place the bit in the chuck as far as it will go and
lift slightly before tightening.
• Tighten firmly by turning the sleeve clockwise.
• To remove the bit, proceed in reverse order.
Selecting the operating mode (fig. C)
This tool can be used in two operating modes:
• Select the required operating mode by aligning
the symbol on the mode selector (4) with the
arrow (13) on the housing.
WALT Forward/reverse slider (fig. D)
• To select forward or reverse rotation, use the
forward/reverse slider (2) as shown (see arrows
on tool).
Recommended charging temperature:
approx. 24 °C.
Drilling:
for steel, wood and plastics.
Hammerdrilling:
simultaneous rotating and impacting for
concrete and masonry drilling operations.
20