To Fix The Unit On The Mounting Plate; Wireless Lan Adapter; About The Wireless Lan Adapter; To Install The Wireless Lan Adapter - Daikin CTXM15N2V1B Manual De Instalación

2 Pass the drain hose and refrigerant pipes through the wall hole.
5.5.3

To fix the unit on the mounting plate

1 Set the indoor unit on the mounting plate hooks. Use the " "
marks as a guide.
2 Press the bottom frame of the unit with both hands to set it on
the bottom hooks of the mounting plate. Make sure that the
wires do NOT get squeezed anywhere.
Note: Take care that the interconnection cable does NOT get
caught in the indoor unit.
3 Press the bottom edge of the indoor unit with both hands until it
is firmly caught by the mounting plate hooks.
4 Secure the indoor unit to the mounting plate using 2 indoor unit
fixing screws M4×12L (accessory).
5.6

Wireless LAN adapter

5.6.1

About the wireless LAN adapter

For detailed specifications, installation instructions, setting methods,
FAQ, declaration of conformity and the latest version of this manual,
visit http://www.onlinecontroller.daikineurope.com.
INFORMATION
▪ Daikin Industries Czech Republic s.r.o. declares that
the radio equipment type inside of this unit is in
compliance with Directive 2014/53/EU.
▪ This unit is considered as combined equipment
according to the definition of Directive 2014/53/EU.
INFORMATION
Install the wireless LAN adapter after finishing the indoor
unit installation. Refer to
adapter" on page 9.
Basic parameters
What
Frequency range
Radio protocol
Radio frequency channel
Output power
Effective radiated power
Power supply
CTXM15+ATXM20~50+FTXM20~71N2V1B
Daikin room air conditioner
3P482320-8K – 2018.09
"5.6.2 To install the wireless LAN
Value
2400 MHz~2483.5 MHz
IEEE 802.11b/g/n
1~11
0 dBm~18 dBm
17 dBm (11b) / 13 dBm (11g) /
12 dBm (11n)
DC 14 V / 100 mA
5.6.2

To install the wireless LAN adapter

DANGER: RISK OF ELECTROCUTION
▪ Turn off the power supply before installing the wireless
LAN adapter.
▪ Do NOT handle the wireless LAN adapter with wet
hands.
▪ Do NOT let the wireless LAN adapter get wet.
▪ Do NOT disassemble, modify or repair.
▪ Grip the connector when disconnecting the connecting
cord.
▪ Turn off the power supply if the wireless LAN adapter
was damaged.
Symbol Explanation
The protection of appliances marked with this symbol
is ensured by double insulation and does not require
a safety connection to electrical earth (ground).
To connect the wireless LAN adapter with the unit
1 Remove the tape holding the connecting cord connector.
Class 15~42
a
a Tape
2 Cut the clip and remove the connector from the protection
sleeve.
a
b
a Protection sleeve
b Clip
3 Remove the upper case of the wireless LAN adapter.
a
b
c
a Upper case
b Printed circuit board of the wireless LAN adapter
c Lower case
4 Attach the connecting cord connector (white).
5 Installation
Class 50~71
a
Installation manual
9