Dc Voltage Measurement - HT Italia HT9014 Manual De Instrucciones

4.3.2. DC Voltage measurement

Maximum input for DC Voltage measurements is 1000V. Do not take any
voltage measurement exceeding this limit in order not to risk electrical
shock or damaging the tester.
1. Rotate the switch on
2. Insert the red test lead plug into VΩ
plug into COM jack (Fig. 4)
3. Connect the two long ends of test leads to the desired circuit, then reading will be
displayed
4. When "O.L." symbol is displayed, the result is over the maximum value that the
instrument is able to measure
5. For HOLD, MAX/MIN and REL features please refer to § 4.2
• Due to the high input impedance is possible that the meter performs the
zero of the display taking longer
• The possible blinking values shown at display with open input terminals
are not a problem of the meter and these values will not be added to
the measured value
Fig. 4: Taking DC voltage measurements
position
EN - 9
CAUTION
CAPHz%Temp jack and the black test lead
CAUTION
HT9014 - HT9015