Idiomas disponibles
Idiomas disponibles
_hb
ARNING: Always wear
safety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
2 - 1/2 inch wrenches
(or adjustable
wrenches)
2 - 9/1 6 inch wrenches
(or adjustable
wrenches)
2 - 3/4 inch wrenches
(or adjustable
wrenches)
1 - Pliers
(to spread
cotter
pin)
1 - Screwdriver
1 - Measuring
tape or ruler
/---'4
o
Figure 1
Figure
1 shows the snow
thrower
in the
shipping
position.
Figure
2 shows the snow
thrower
com-
pletely
assembled.
References
to the right or left hand side
of the snow thrower
are from the view-
point of the operator's
position
behind
the unit.
TO REMOVE SNOW THROWER FROM CARTON
1.
Locate
all parts
packed
separately
and remove
from the carton.
Auger
NOTE:
Place fuel stabilizer
in a
Drive
safe place until needed
for storage.
Lever
2.
Remove
and discard
the packing
material
from around
the snow
thrower.
Shifter
Lever
3.
Cut down all four corners
of the car-
ton and lay the panels
flat.
4.
Cut the straps that secure
the axle
to the pallet.
5.
For shipping
purposes,
the height
adjust
skids
are attached
to the
pallet.
Remove
the screw
that se-
cures
each height
adjust
skid to
the pallet.
See Figure
2.
6.
Roll snow thrower
off the pallet by
pulling
on the lower handle.
CAUTION:
DO NOT back over con-
trol cables.
7.
Remove
all packing
material
from
the unit.
8.
Cut ties securing
the clutch
contro!
cable to the lower handle
and lay
cable back away from the motor
frame.
F 0410109L
7
Drive Lever
Crank Assembly
Chute
Deflector
Height Adjust
Skid
Screw
Figure 2
