Parameterizing The Machine - Furius FIX 181 MINI Manual De Instrucciones

Instructions for setting and parameterizing the machine
9.
Turn the knob to adjust the current.
The adjusted value will be shown on the display
Preparation for applying manual metal arc welding (MMA/SMAW)
Connect the work clamp (ground) to the piece to be welded. Make sure there is a good electrical
connection in the equipment. Remove any rust, paint, or any contamination using a wire brush or
polisher (grinder, angle grinder) before connecting.
If you use a metal table for welding, you should regularly check the connection of the work clamp
(ground) for signs of contamination or corrosion. A good ground connection is essential for good
results in the welding application.
Electrode ignition
Insert the electrode into the jaw of the electrode holder by pressing the lever on the electrode
holder. Make sure you have proper eye protection (face shield) before you start welding.
Note: UV radiation damage is particularly high during arc start.
To start the arc, scratch the electrode over the spot to be welded in a similar way to how a match
is lit. The 80V no-load voltage ignites the electrode quickly, and direct current (DC) allows the
electrode to melt evenly. If you are a beginner do not expect good results on the first attempt, take
training courses and courses in welding.
16