Whirlpool WHSS 90F TS K Instrucciones De Uso página 16

Calibrating the hood
Please note: this must be done with the appliance on standby, i.e. one minute after switching off the motor.
Press and hold the T4 button for five seconds.
Extraction speed 1 will come on and the T4 button will flash to indicate that hood calibration has started (this will take approximately
15 minutes).
Please note: To stop the calibration process, press and hold the T4 button for five seconds. Calibration will then be invalidated and
will therefore need to be repeated.
Please note: Calibration will be carried out automatically when the power supply to the product is switched on for the first time. T4
will flash. Wait 15 minutes for calibration to complete.
Selecting the hob type
Please note: this must be done with the appliance on standby, i.e. one minute after switching off the motor.
Press and hold the T9 and T10 buttons for five seconds.
The T9 and T10 buttons will light up.
If using gas to power the hob, press the T9 button – the button will flash to indicate that this has been selected.
If using electricity to power the hob, press the T10 button – the button will flash to indicate that this has been selected.
Once pressed, the button will flash for three seconds to indicate that your selection has been saved.
MAINTENANCE
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent. DO NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Maintenance of the anti-grease filters
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Maintenance of the charcoal filter
It absorbs unpleasant odors caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths (or when the filter saturation indication
system – if envisaged on the model in possession – indicates
this necessity).The charcoal filter may NOT be washed or
regenerated.
CLEAN WITH TOOLS OR
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
To replace lights, contact authorised spare part center.
16