Cleaning And Maintenance; Changing Light Bulbs; Problem Solving - Teka DHI Serie Manual De Instrucciones

Cleaning and maintenance

During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the product
instructions.
• If your kitchen hood is painted, use lukewarm water
and a neutral soap.
• Never use metallic scourers, nor abrasive or corrosive
products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
Cleaning the metal filters
• To remove the filters from their fittings, press lightly on
the locks and then pull them off.
• The metal filters can be cleaned by soaking them in
hot water with neutral detergent until the fat dissolves
and then rinsing them under the tap or using special
anti-grease products. They can also be washed in a
dishwasher. In this case, it is advisable to stack them
vertically to avoid food residues to stick to them.
• Cleaning in a dishwasher may damage the metallic
surface (blackening it), although this will not affect its
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their
useful life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
For changing the light bulbs please contact the
manufacturer's nearest Technical Service.

Problem solving

Possible cause
The mains cable is not
connected to the network.
There is no current in the
network.
Filters are saturated with fat.
Obstruction in the air outlet.
Active charcoal filters (Optional)
fat retention capacity. Once clean, leave them to dry off
and then fit them onto the kitchen hood.

Changing light bulbs

Solution
Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
network.