Idiomas disponibles
Idiomas disponibles
Operation Advice
Remove the McPherson spring strut.
Select jaws according to table (page 32-46) and mount on the
spring compressor. Fit the retaining bolts and tighten firmly.
It is very important for your safety that the bolts of the jaws
are firmly tightened.
Rotate the drive nut to drive the jaws apart to match the length of
the spring and to compress as many windings as possible.
Place the coil spring compressor in the built-in protective accessory
in a suitable vice.
Place the spring strut onto the coil spring compressor. Take care
that the seating of the spring windings in the jaws is correct.
With an impact wrench or a racket spanner, turn the drive nut until
the upper support bearing is free. Additional compressing is permit-
ted.
CANVIK PLUS will need approximately 185 Nm to
compress 2250 kg.
