Home Depot GLACIER BAY 461-3001 Guía De Uso Y Mantenimiento página 5

Installation (continued)
4
Installing the spout assembly
□
Install the spout assembly (A) onto the
connector (T). Be sure the spout assembly (A)
is resting rmly on the deck.
□
Push down on spout assembly (A) and tighten
set screw (B) with the Hex wrench
(Hex: 3.2mm, C).
6
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
□
From underneath the deck, insert the cold end
valve (N) with the rubber washer (O), metal
washer (P) and mounting nut (Q) through
the hole on the right (cold) side.
□
From above, thread the ange (L) onto the
valve body (N).
□
Tighten the mounting nut (Q) using a basin
wrench, so that the ange (L) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (M)
on the left (hot) side.
A
C
B
T
5
Removing the mounting kits
□
Adjust the rubber washers (O), metal
washers (P) and mounting nuts (Q) to the
bottom of valve bodys (M & N).
M
5
Please contact 1-855-HD-GLACIER for further assistance.
M
O
P
Q
L
N
O
P
Q
HOMEDEPOT.COM
N
O
P
Q