Machine Inspection - Urrea PVC855 Manual De Usuario

· Start the motor using the recoil starter. (If the
motor is fitted with an on/off switch this must
first be turned to ON before starting. )
· Correct moisture content in soil is vital to
proper compaction. Water acts as a lubricant
to help slide soil particles together. Too little
moisture means inadequate compaction; too
much moisture leaves water-filled voids that
weaken the soil's load bearing ability.
· Compaction of dry materials will be facilitat-
ed by moistening with a water hose fitted with
a sprinkler.
· Excessive watering or water content will
cause the machine to stall.
· The water tank kit is recommended when the
machine is used on bituminous surfaces as the
water flume prevents a build up of material on
the underside of the plate.
CAUTION: Inspection and other services
should always be carried out on hard and level
ground with the motor shutdown.
INSPECTION AND MAINTENANCE SERVICE
TABLES:
To make sure your plate compactor is always
in good working condition before using, carry
out the maintenance inspection

MACHINE INSPECTION

Starting check (every day).
Loosened of lost screws (every
day).
Damage of any part (every
day).
Function of controlling system
part (every day).
Vibrator oil check
Vibrator oil replacement
V-belt (Clutch) Check
MOTOR CHECK
For details, see separate motor manual.
Leakage of oil fuel (every day)
Tightness of fastening threads
(every day)
Engine oil check and replen-
ishment (every day) (Replen-
ish to specified Max. Level)
Engine oil replenishment
Air cleaner cleaning
for operation under normal conditions. Adjust
your inspection intervals based on the number
hours plate compactor is in use, and particular
working conditions.
should be replaced every 2 years.
Daily Service
• Check for leakage of fuel or oil. Remove
soil and clean the bottom of compaction plate
• Check motor oil. Check for loose screws in-
Every 8 hrs
cluding tightness. See Table below (Tightening
torque), for retightening.
Every 8 hrs
Material
4T
Every 8 hrs
6-8T
11T
11T
Every 8 hrs
(In case counter-part is of aluminum)
(Threads in use with this machine are all right handed)
Every 100
Material and quality of material is marked on each bolt, and screw.
hours
Every 100
Changing Vibrator Oil
hours
When changing the vibrator oil, remove the
Every 100
drain plug located at the bottom-right of the
hours
vibrator, and simply tip the compactor to drain
the oil. Note that the oil will drain more easily
while it is hot. Replace the oil with 200 ml of
10W-30 motor oil.
E N G L I S H •
CAUTION: These inspection intervals are
CAUTION: Fuel piping and connections
6 mm 8 mm 10 mm 12 mm
70 150 300 500
100 250 500 800
150 400 800 1200
100 (6 mm) 300 - 350 (8 mm) 650 - 700 (10 mm)
U se r's m a nu a l
Every 8 hrs
Every 8 hrs
Every 8 hrs
At first 20
hours, then
every 100
hours
Every 50
hours
14 mm 16 mm 18 mm 20 mm
750 1100 1400 2000
1300 2000 2700 3800
2000 2900 4200 5600
13