Garland MONTANA 1420 Manual De Instrucciones página 54

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
8.2.4. OIL FILTER
The oil tank is provided with a filter (2). This element
is located at the extreme end of the oil hose and it
can be removed oil opening with the help of a piece of
wire bent into a hook or similar device.
Inspect the oil filter
periodically. Do not allow
dust to enter the oil tank.
The obstruction of the
filter will make it difficult
to start the engine or it will
produce abnormalities in
the performance of the engine.
Inspect the oil filter and if it is dirty, replace it with a
new one.
If the inside of the oil tank is dirty, it can be cleaned by
rinsing out with petrol.
8.2.5. CHECKING THE SPARK PLUG
Starting up or ignition failures are frequently caused
by a dirty spark plug. Clean the spark plug and check
that the spark plug light is within the correct interval.
(0.6-0.7mm).
8.2.6. CLEANING THE CYLINDER REFRIGERATION
VENTS
The cylinder refrigeration vents
are responsible for cooling
the piston and the cylinder by
means of the entry of air.
The vents must always be kept clean, free from
material that could block air from entering. Dirty vents
mean that the engine will overheat, causing it to seize.
Check and clean the cylinder vents periodically.
8.2.7. BAR CHAIN MAINTENANCE
Invert the bar periodically, in order to avoid it wearing
out unevenly. The edges of the bar rail must always be
kept square.
Check the wear and
the shape of the
edges. If you observe
that the edges have
lost their shape, or a
side wing is deformed,
replace the bar.
When unassembling
the chain bar, remove
the sawdust from the
bar (2) and the oil hole
(1). Oil the chain sprocket.
54/172
Tabla de contenido
loading

Tabla de contenido