Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
alarm valid for all channels, active fan cooling system with only one
level valid for lighting H and switching off L.
With F=1 is possible to set only four parameters: P, A, L, H.
F=2: group of eight active channels, only one level for alarm and pre
alarm valid for all channels, active fan cooling system with only one
level valid for lighting H and switching off L, control of fan cooling
system also with time parameter t.
With F=2, in addition to the parameters set with F=1, is possible to
set a parameter t in minutes, t is the minimum time that must elapse
before the device turn off the fan cooling system. This guarantees
a minimum time of activation for fan cooling system independently
from the value of L.
F=3: Independent programming for each channel of all levels P, A,
L, H.
in this mode it is also possible to accede to RS485 section.
With F=3 the device asks in sequence the following parameters:
Time t in minute, t is the minimum time that must elaps before the
device turn off the fan cooling system. This guarantees a minimum
time of activation for fan cooling system independently from the
value of L.
For each channel appears the word CH(n) with n (1-8), by means of
the buttons UP and DOWN you choose if a channel is active or not,
in affirmative case, it is asked to put the P and A parameters.
Afterwards the word FAn appears, with the buttons UP and DOWN
you choose if fan cooling system is active or not for that channel, in
affirmative case, it is asked to put the L and H parameters, in case
the channel is not active or fan cooling system is deactivated for that
channel the device asks the choice for the next channel.
At the end it is asked to configure a RS485 section.
The S letter sets the communication speed in bit for second (bps),
see the following descriptions:
15
Tabla de contenido
