Alibrate; Pdates - Numark D2 Director Manual De Referencia

Calibrate
This function is used to calibrate the pitch sliders. Your D2
Director has been pre-calibrated at the factory, but the
characteristics of the sliders may change slightly over time. If the
top, center and bottom positions no longer align with the expected
pitch range you should run this calibration routine.
Select Calibrate, then when prompted:
1. Move both sliders to the fully upward position (to the -%
symbol)
2. Select Next
3. Move both sliders to the center position
4. Select Next
5. Move both sliders to the fully downward position (to the +% symbol)
6. Select Next
Calibration is now complete. Press the Utility button to exit.
Note: If you mix up the calibration procedure by swapping over the minus and plus ends of the
scale, the pitch slider will have no effect! Simply re-run the calibration.
Updates
The Updates page shows the current software version of the D2
Director. Please check http://www.numark.com/d2/ regularly for
available software upgrades.
upgrade on the website is higher than the version of the current
software on your D2 Director, please follow the upgrade procedure
outlined in the next section of this manual.
NEXT
NEXT
NEXT
If the version of the software
26