Numark D2 Director Manual De Referencia página 22

Looping Controls
The D2 features seamless looping, which means that if
you define a loop, there is no delay when the music
loops back to the beginning. This looping feature lets
you be very creative with your mixes, allowing you to
extend desired sections of a song for as long as you
want, or create remixes on the fly.
11.
LOOP IN - This is the point where you would like a loop to start. By default, a "loop in" point is automatically
set to the current cue point (defaulting to the the beginning of the track) unless a new "loop in" point is set. To
define a new "loop in" point, press the LOOP IN button when the song reaches the desired point where you
would like a loop to begin. The LOOP IN button will light, indicating a new "loop in" point has been set. You
can now press the RELOOP button to immediately go back to the "loop in" point and begin playing. If you wish
to change the "loop in" point, just press the LOOP IN button again.
Please note: The LOOP IN button can also be used to create a live cue point. Once you press LOOP IN, a
cue point will be set at that location in the music. You can always return to this cue point by holding down CUE
and pressing the LOOP IN button – the deck will pause and return to the LOOP IN point. You can resume
playback from this point by pressing the PLAY button.
12.
LOOP OUT - Sets the end point of the loop. The first time you press LOOP OUT while a song is playing, the
LOOP OUT button will blink and the song will begin playing in a seamless loop starting from the "loop in" point
and ending at the "loop out" point. To release or end the loop, press LOOP OUT a second time and play will
continue forward when the song passes the previously set loop out point. The LOOP OUT button will then be
continuously lit, indicating that the loop is now in memory for re-looping purposes.
Please note: The LOOP OUT button can also be used to create a live cue point. Once you press LOOP OUT,
a cue point will be set at that location in the music. You can always return to this cue point by holding down
CUE and pressing the LOOP OUT button – the deck will pause and return to the LOOP OUT point. You can
resume playback from this point by pressing the PLAY button.
13.
RELOOP - Repeats play "stutters" from the "Loop In" point. If a loop has been set, it plays and repeats a
previously set loop, until it is released by pressing LOOP OUT a second time.
Press LOOP IN to set the beginning of the loop,
then press LOOP OUT to set the end point of the
loop. Once you press LOOP OUT, the D2 will loop
between these two points. If you press LOOP OUT
again, the D2 will exit the loop and continue playing
normally.
The "Loop In" point can also be used
as a way to "stutter" play beginning
from a certain point in a song. Just
press LOOP IN to set the "Stutter"
point, then press RELOOP to begin
play from the "Stutter" point.
time you press RELOOP, the D2 will
jump back to the "Stutter" point and
play from that point.
22
If you press LOOP IN but
then decide you want to
set a different "Loop In"
point, just press LOOP IN
again. Then press LOOP
OUT to start looping
between the in and out
points.
Each