Inserting The Memory Card - Perel WLC002 Manual Del Usuario

5.4 Inserting the Memory Card

Install the memory card before switching on the camera.
Unlock the write protection and insert a formatted memory card into the card slot. Do not force to
avoid damaging the card. We recommend using a TF card, class 6 or higher, max. 32 GB.
At first use, wait for the memory card to reach ambient temperature. Therefore, the camera may
present some delay.
To avoid damage, protect memory card from water, strong vibrations, dust, hot sources and direct
sunlight.
Note that, if the memory card is full, the camera will stop recording automatically and the LEDs will
go out.
6. Operation
6.1 System Setup and Test
1. Slide the mode switch to the TEST position.
2. Press menu to open the setup menu.
3. Press up or down to navigate through the menu or options, and press OK to confirm.
4. Press video or capture to switch between these two modes.
5. Press menu to exit the setup menu.
6.2 Basic Working Mode
Slide the switch to the on position. After 15 seconds the camera will enter the standby mode.
When a motion is detected, the camera take photos or record video automatically according to the
settings.
6.3 Basic Settings
Mode
Slide the mode switch to the on position and select the working mode. In capture mode, the camera
will take pictures only. In video mode, the camera will record. In capture + video mode, the camera
will take a picture first and then record.
Options: Photo → Video → Photo & Video
V. 01 – 17/06/2020
WLC002
7 ©Velleman nv