Test With Dummy Load; Pump Over-Temperature Test; Functional Test - Varian Turbo-V 70 PCB Manual De Instrucciones

Test with Dummy Load

− Connect the 48Ω or the 78Ω dummy loads to the
pump connector pins B, C, D, as shown in the
previous figure.
− Disconnect the potentiometer, set it to 10 KΩ, and
then reconnect it.
− Connect the power cable.
− Push the START and CURRENT pushbuttons and
check the front panel display as shown in the
following table.
During start-up
without
Soft Start mode
With
48Ω
dumm
y load
1.4 A
Current ±10%
80 W
Power ±10%
Speed 34
±4 KRPM
Temperature
52 °C
±2 °C
− Check the 3-phase ac output voltage.
After start up it should be:
42 Vac with 78Ω dummy load and
42 Vac with 48Ω dummy load.
Press the STOP pushbutton and remove the power
cable.
After
start-up
With With With
78Ω 48Ω 78Ω
dumm dumm dumm
y load y load y load
0.6 A 1.3 A 0.45 A
40 W 70 W 24 W
75 9 75
52 °C 52 °C 52 °C

Pump over-Temperature Test

− Disconnect the potentiometer, set it to 5KΩ, and
then reconnect it.
− Disconnect the dummy loads.
− Connect the dummy loads.
− Push the START pushbutton.
By pressing the CURRENT pushbutton, the
temperature reading should be 71 °C ±2 °C. All the
other values should be zero.
− Check the 3-phase ac output voltage.
It should be zero.
− Press STOP and remove the power cable.

Functional Test

Perform the functional test with the turbopump, taking
care to check the ramp sequence and start up time.
65
TECHNICAL INFORMATION
87-900-871-01 (B)