Conglom QL109 Manual Del Usuario página 11

Installation (continued)
INSTALLING THE FAUCET
- Connect the sprayer head (1) to the sprayer
head connector (2).
- Remove the gasket (3), metal washer (4),
and retaining nut (5) from the faucet.
- Install the faucet through the hole
in the sink .
- From underneath, secure the faucet to the
sink with the gasket (3), metal washer (4),
and retaining nut (5).
- Tighten the retaining nut (5) by hand until
it is snug . Use a wrench to tighten it down .
Gently tighten the two screws on the
retaining nut . Do not overtighten .
- Hand-tighten the hose (6) to the faucet
outlet (7). Tighten the fittings using two
wrenches. Hold the faucet outlet (7) steady
with a wrench while turning the hose fitting
with another wrench until it is snug .
NOTE: Failing to use two wrenches can damage the
faucet. Do not overtighten.
- Push the sprayer head (1) into the faucet
neck. Install the counterweight (8) a couple
of inches from the bottom of the hose on
the side closest to the sprayer head (1).
There should be no slack in the hose and it
should retract freely .
- Connect the water supply lines (not
supplied) to the faucet.
- This faucet is equipped with standard
1/2" NPS male thread connectors that are
compatible with standard 1/2" FIP water
supply lines .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Sprayer Head
Connector (2)
Sprayer
Head (1)
Gasket (3)
Retaining Nut (5)
Counterweight (8)
Faucet outlet
Hose
11
Faucet body
Sink
Metal Washer (4)
Screws
Faucet Outlet (7)
Hose (6)
Fig. 12
Water Connectors
1/2" NPS thread
1/2" FIP water supply
line compatible
(not supplied)
Fig. 13
CONGLOMKB .COM