Troubleshooting - Silverline 326579 Manual Del Usario

GB
Maintenance
WARNING: Always remove the plug from the mains power supply before carrying out any
maintenance/cleaning of the Battery Charger (13). Remove the Battery (7) before carrying
out any maintenance/cleaning of the drill.
Note: Both the drill and the Charger contain no user-serviceable parts. If the device does
not perform as outlined in this manual, return it to an authorised Silverline service centre
for repair.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the machine's service life. Clean the body of your machine with a
soft brush, or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
Storage
• Store this tool in its original case where provided after it has been thoroughly cleaned
• Store this tool carefully in a secure, dry place out of the reach of children. Store in its
original case if a case is provided
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, batteries, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools or batteries

Troubleshooting

Problem
Red LED does not illuminate and
Battery (7) not charging
Battery has low capacity
Drill cannot be switched on
(Trigger Switch (10) does not
move)
Drill does not start when Trigger
Switch is pressed
Screws do not reach deep
enough into the workpiece
Screws are driven too deep into
the workpiece surface
8
Possible cause
Battery not fully seated
Battery Charger (13) not powered
Battery not being fully charged
Battery has been charged over 300 times and capacity
has started to reduce
The Forward/Reverse Switch (8) may be in the middle
("locked") position
Battery completely discharged
Defective Battery
Drill defective
Not enough torque; Torque Selector (3) setting too low
Low battery voltage
Too much torque; Torque Selector (3) setting too high
Solution
Clean Battery Contacts (14)
Recheck mains connection
Charge the Battery until Red LED (16) is extinguished
This is normal for batteries. Contact your Silverline dealer to purchase a
replacement battery
Slide the Forward/Reverse Switch either to the left or right
Recharge Battery or replace with a fully charged battery
Replace Battery
Contact your Silverline dealer or authorised service centre
Choose a higher torque setting
Recharge Battery or replace with a fully charged battery
Choose a lower torque setting