Adjusting The Receiver Channel - Sennheiser RS 4 Instrucciones Para El Uso

Putting the receiver into operation
Insert the BA 151 rechargeable accuplug
Switching the headphone receiver on
Switch on the headphone receiver and adjust the volume with control

Adjusting the receiver channel

Transmitter and headphone receiver have to work on the same frequency:
Put the transmitter and the headphone receiver into operation as described above. Switch on the signal
source! If possible, switch off its loudspeakers.
Select a transmission channel (1, 2 or 3) on the transmitter with switch
Adjust the volume control
Slowly turn control
receiver's AFC (Automatic Frequency Control) circuitry stabilises your adjustment.
Transmitter and headphone receiver are now operating on the same frequency.
Simultaneous operation of several systems
Your neighbour also likes listening to music with an RS 4? No problem! With switch
a different channel on each transmitter. Then set the headphone receivers to the respective frequencies
(with control , as described above). Observe a minimum distance of 2 m between two transmitters.
into the battery compartment on the headphone receiver.
on the headphone until you can hear a low hissing.
(" ") on the headphone until you can hear the audio signal loud and clear. The
TUNE
.
.
, you simply select
17