Tabla de contenido
+
+
Felt Packing
Cale en feutre
Empaquetadura
de fieltro
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
+
+
Groove
Rainure
Ranura
Replacing Belt
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
+
Install
New Belt
Poser la
nouvelle courroie
Instalación
de la correa
+
End Cap
Bouchon
Tapa del extremo
Cleaning Agitator
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
Remove lower plate.
Lift rear belt cover and remove felt
packing.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
Clean agitator.
Loop new belt (Panasonic Type UB8
only) around motor shaft and agitator
pulley; see illustration for correct belt
routing.
Reinstall agitator back into nozzle
housing grooves.
Close rear belt cover and reinstall felt
packing.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
Clean agitator after every five uses
and every time the belt is replaced.
Remove lower plate.
Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
Remove agitator.
Remove any string or debris located
on the end caps, washers or agitator
shaft.
Reinstall agitator and lower plate.
- 32 -
Tabla de contenido
