Klarstein 10029304 Manual Del Usario página 15

USE AND OPERATION
Before first Use
• Remove the exterior and interior packing
• Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded. To level your appliance, adjust the front legs at the bottom of
the appliance.
• For recedes installation away from direct sunlight and sources of heat (stove, heater,
radiator, etc.).Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold or hot ambient temperatures may
also cause the appliances not to perform properly.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
• Caution: Please keep the appliance away from substance, which can cause
ignition.
Placement
It is recommended that you installed the wine cooler in a place where the ambient
temperature is between 10-26 °C. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected and the range
of 1 1-18 °C may not be reached. The temperature may fluctuate depending on whether
or not the interior light is on or off or whether the bottles are located on the upper,
middle or lower section.
Temperature Settings
There are three touch-buttons on the control panel: The arrow button increases or
decreases the set tempera- ture by 1 °C (temp range is 1 1-18 °C). The light button turns
on or off the interior light.
This product is designed for max imum cooling of 14°C below ambient temperature.
When the ambient tem- perature around 25 °C or less, unit can maintain a temperature
range between 1 1-18 °C.
EN
15