Changing The Gas Cylinder - Krampouz Saveur Instrucciones De Uso

pressure regulator to the hose and gas cylinder as per the instructions supplied with the
pressure regulator and hose. Then, perform a leak-tightness test by following these
instructions:
 Check leak-tightness by using soapy water away from any heat source (cigarettes,
electrical appliances, etc.).
 Never test leak-tightness using a flame.
 Put soapy water on all couplings, open the gas inlet and then check for the formation of
bubbles.
 If bubbles = leak; close the gas cylinder and tighten the couplings, then perform
another leak-tightness test.
 If the leak persists or comes from another part, stop using your plancha and contact the
dealer.
Never use a leaky appliance.

CHANGING THE GAS CYLINDER

Always change the gas cylinder with the control levers and the gas cylinder valve closed.
Change the gas cylinder in a well-ventilated location away from any heat source (cigarettes,
electrical appliance, etc.).
Whenever you change the gas cylinder, perform a leak-tightness test.
Use
POWERING ON
 The appliance is ready for operation
 Open the gas cylinder valve
 Open the plancha valve by turning the lever to the high flame position (drawing on the
ring around the lever).
 Push the lever to this position against the frame for a few seconds, then activate the
electronic lighter to switch the burner on. Check that the burner is completely lit by
looking through the openings on the side of the appliance.
 Maintain pressure on the lever for between 5 and 10 seconds to engage the
thermocouple safety system (see figure 5).
 Then release the lever and allow the burner to heat the cooking plate to the appropriate
temperature.
 Preheat the plancha by setting it to the high flame position for 5 to 10 min, then reduce
to the low flame position.
 Your appliance is ready to be used.
- 19 -