Setting Toe To Zero - Ki Mobility TSUNAMI AL Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
J. Setting Toe to Zero
NOTE: A wheelchair equipped with 0° camber plugs cannot have a toe-in-toe-out condition. This
adjustment is only required when using 2°, 4°, 6° and 8° camber adapters.
Toe refers to how well the rear wheels of the chair are aligned relative to the ground. It affects how
well the chair will roll. Drag or rolling resistance is optimally minimized when the wheel toe is set to
zero.
Setting the toe to zero:
1. Loosen the four cap screws (Fig. 12:A and 13:A) (2 per side) that secure the camber tube
clamp.
2. Rotate the camber tube (Fig. 12:B and 13:B) until the screws (C) that secure the camber
spuds are level with the ground. The toe is now set at zero.
3. Before tightening the screws (Fig. 12:A and 13:A), make certain that the camber tube is
centered left-to-right relative to the wheelchair frame. There should be an equal gap on both
sides or none at all.
4. Tighten screws in a balanced fashion - tighten one screw to 50 in/lbs and then the second to
50 in/lbs. Return to the first screw and tighten to 80 in/lbs and then return to second screw
and tighten to 80 in/lbs. Repeat on opposite side.
Tsunami
C
B
C
Fig. 12
A
Little Wave
Fig. 13
A
25
B
C
C
A