Ki Mobility Catalyst 5VX Manual De Instrucciones página 35

IV. WHEELCHAIR USE & CONFIGURATION
S. Anti-Tips (Continued)
How to Adjust the Position of the Swing-In Anti-Tip Receivers (Fig. 24)
1. Remove the bolts and nuts that connect the anti-tip tube receiver to the side frame of the
chair.
2. The holes are in 1" (2,54 cm) increments so it can be moved farther up or lower on the frame.
Place the bracket at the desired height.
3. Reinsert the bolts and tighten (If the bolts also connected the armrest and the axle plate you
may need to contact your supplier for additional hardware because different bolt lengths
may be required).
4. Adjust the second anti-tip receiver the same way. Both anti-tips should be in the same
position.
How to Rotate the Swing-In Anti-Tips (Fig. 25)
1. Push down on the anti-tip knob (Fig. 25:A).
2. Swing the anti-tip towards the inside of the chair.
3. Adjust the second anti-tip tube the same way. Both anti-tips should be in the same position.
Fig. 24
Fig. 25
A
33