Intended Use; Before First Use - OK. OBO 3222 Manual De Instrucciones

INTENDED USE

This product is designed for heating and cooking and baking foods on baking tray, cooking grate or in a
suitable pan. Any other use may result in damage to product or injuries.
The Imtron GmbH assumes no liability for damage to the product, for property damage or for personal
injury due to careless or improper usage of the product, or usage of product which does not meet the
manufacturer's specified purpose.
COMPONENTS
A. Transport and assembly handles
B. Status indicator light
C. Temperature knob
D. Display
E. +/- and function button
F. Mode selection knob
G. Mounting holes
H. Baking tray
I. Grate
J. Oven door
K. Oven door handle
L. Front frame with seal
M. Baking tray slots
N. Cavity bottom with lower heat
O. Upper heat / grill
P. Circulating fan with heating element (not shown)
Q. Oven light (not shown)
R. Screws with spacers and caps
S. Heating fan (not shown)

BEFORE FIRST USE

• Remove the product and accessories from the original packaging carefully. For disposal of the original
packaging, follow applicable legal requirements. If you have questions about correct disposal, contact
your local authority.
• Check the package contents for completeness and damage. If the package content is incomplete or
damages can be found, contact your place of purchase immediately.
• After unpacking clean the product, see chapter Cleaning and care.
• To remove any manufacturing residues and odors in the oven before first use, operate the built-in
oven for 15 minutes at 200 °C. Follow the instructions of chapter OPERATION.
INSTALLATION
Note: The built-in oven is equipped with power cord and plug. Make sure before installation that the
wall outlet is at the desired place of installation.
Consider the dimension (in mm) of the product and the installation opening. Make sure a
1
corresponding recess on the back side of the kitchen cabinet is available.
Place the product in front of the opening and put the power plug with power cord through the
2
hole in the back side of the kitchen cabinet.
Put the product into the installation opening. Insert the screws with spacers into the holes in the
3
front frame and screw the oven with the cabinet. Then connect the caps on the screw heads.
Connect the power plug to a suitable wall outlet. A beep sounds up and the time 12:30 flashes in
4
the display. Set the correct time before first use.
IM_OBO3222_160311_V01_HR.indb 21
21
EN
10/3/16 4:34 PM