Using The Timer - Pro-Elec PEL00941 Manual De Instrucciones

ASSEMBLY
Fitting the Feet
• Carefully turn the unit upside down. Using the
four 12mm screws provided, affix the feet to
the underside of the heater (see right).
OPERATION
• Before connecting the appliance to the mains, make sure that all switches are set
to the "OFF" position.
• Insert the plug of the heater into the main socket.
• Adjust the thermostat to a desired temperature level.
• Turn on the heating element using the two rocker switches on the side panel. They
will illuminate when the heating elements are on.
• The third rocker switch can be used to turn the fan on to circulate warm air in the
room when the heating elements are
on (PEL00941 only).
• The fan can be used with the
heating elements switched off to
help circulate cool air. The switch will
illuminate when the fan is on.
Note: It is normal when the heater is turned on after a period of no use for it to emit
some odour. This will disappear after the heater has been on for a short time.

USING THE TIMER

• Set the time by adjusting the clock wheel in a clockwise direction only, so that the
arrow points to the current time.
• Set the slide switch position to the clock setting.
• Set the time periods required for heating by sliding
the red teeth outwards. Each tooth represents
approximately 15 minutes.
• Sliding the teeth back in to the centre will turn
the heater off for that period. To run the heater
continuously set the slide switch to the (I) position.
• In position "O", the timer continues to run but no
power is fed to the heater.
GB