Contents Of Carton - GMC SDSHD550 Manual Del Usuario

• Before drilling, check that there is sufficient clearance for
the drill bit under the workpiece
• Use both hands when operating this tool
• Use auxiliary handles supplied with the tool
• Do not put pressure on the tool, to do so would shorten
its service life
• Drill bits get hot during operation, allow to cool prior to
GB
handling them
• Never use your hands to remove sawdust, chips or
waste close by the bit
• If you are interrupted when operating the drill, complete
the process and switch off before looking up
• Where possible, use clamps or a vice to hold your work
• Always disconnect the hammer drill from the electric
supply before changing a chisel or drill bit
• Examine the chuck regularly for signs of wear or
damage. Have damaged parts repaired by a qualified
service centre
• Always wait until the drill has come to a complete stop
before putting it down
• On completion of the work, disconnect the tool from the
power source and remove chisel/bit from the machine
• Periodically check all nuts, bolts and other fixings and
tighten where necessary

Contents of carton

The GMC SDSHD550 SDS Plus 550W Hammer Drill is
supplied with the following accessories as standard:
• 3 x Drill Bits (8/10/12 x 150mm)
• Dust Protector Cap
• Depth Stop
• Pot of Grease
6