Additional Safety Instructions For Hammer Drills - GMC SDSHD550 Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
b. Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool
or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
e. Always unplug your power tool when leaving
unattended. Such preventative safety measures
reduce the risk of starting the power tool accidentally
by untrained users.
f. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
g. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
h. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work to be performed. Use of the power tool for
operations different from those intended could result in
a hazardous situation.
5. SERVICE
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Additional Safety for Hammer Drills
For safety relating to protective clothing/equipment
and general health hazards relating to power tools;
refer to General and Electrical Safety sections in this
manual
• Important: It is imperative to follow all national safety
regulations concerning installation, operation and
maintenance
• Do not allow anyone under the age of 18 years to use
this tool, and ensure that operators are qualified and
familiar with the operating and safety instructions
• When using the drill, use safety equipment including
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust
• Use metal and voltage detectors to locate concealed
electric, water or gas lines. Avoid touching live
components or conductors
• Extension cable reels used with this tool must be
completely unwound. Minimum conductor cross section:
1.0mm2
• When using this tool outdoors, connect to a power
supply with an RCD device and minimum 1.5mm2
extension cable with water protected plugs in good
working order
• Ensure that the chisel or drill bit is securely fixed in
the chuck. Insecure drill bits can be ejected from the
machine causing a hazard
• Ensure that the lighting is adequate
• Ensure that the drill bit is securely fixed in the chuck.
Insecure drill bits can be ejected from the machine
causing a hazard
• Ensure that the drill bit is in contact with the workpiece
prior to starting up the tool
5
GB
Tabla de contenido
loading

Tabla de contenido