Combining (Baying) Enclosures - Tripp-Lite SmartRack SR42UBEIS Manual Del Propietário

Enclosure Configuration

Combining (Baying) Enclosures

WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of combined
enclosures requires the same stabilizing measures as a standalone enclosure.
1
Arrange the enclosures in the correct position for baying.
2
Each enclosure includes 4 baying brackets
on the adjoining enclosure. The baying connection points already contain screws. Remove the
screw from each baying connection point in the adjoining enclosure.
3
Loosen the screw in each baying bracket and turn each bracket 90 degrees toward the
adjoining enclosure, aligning each bracket with the corresponding baying connection point on
the adjoining enclosure.
4
Connect each bracket to the adjoining enclosure using the screws you removed in step 2, but
do not tighten the screws completely. Adjust the position of the enclosures as needed. If you
want the centers of the enclosures to be 24 inches (61 cm) apart, use the outside hole of the
C
bracket . If you want the centers to be 60 cm (23.6 inches) apart, use the middle hole of
D
the bracket . After connecting all brackets and confirming that the enclosures do not need
further adjustment, tighten all screws.
Note: You may wish to remove the doors from the enclosures before combining them.
Reinstalling the doors afterward is optional. Remove the interior side panels before baying
enclosures if you wish to enable access between enclosures.
A
that correspond to baying connection points
9
1
B
B
2
3
D
C
4
A
90°