Placement - Tripp-Lite SmartRack SR42UBEIS Manual Del Propietário

Enclosure Installation
4
Locate the 2 shipping brackets
5
Use a 13 mm open-end wrench to remove the shipping brackets. Be extremely careful, as the
enclosure could shift unexpectedly after bracket removal. Save the brackets and bracket
hardware for later use.
6
Position at least one person at the front of the enclosure and one person at the rear of the
enclosure. Slowly push the enclosure toward the back of the shipping pallet until all four
casters go over the edge of the pallet and touch the floor. WARNING: Use at least one
assistant when removing the enclosure from the pallet. Be extremely careful when
moving the enclosure.

Placement

1 Use the casters to move the enclosure for a short distance over a level, smooth, stable surface by
pushing it from the front or rear (not the side panels). Do not attempt to roll the enclosure over long
distances. The enclosure should be moved close to its installation location inside its shipping
container before it is unpacked. (Use a forklift or pallet jack to move the shipping container.)
WARNING: Do not push or pull the enclosure at the side panels or pull the enclosure
toward you.
A
that attach the enclosure to the shipping pallet.
4
5
6
1
5
A