Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Remarks: The bracket should be bought by yourself.
If you would like the solar panel install on the roof, please ask a qualified installer to install this solar
system.
2. Connect the connector by the supplied cable.
3. Connect the solar panel cable to the solar panel input connector on the host. All the connection cables
have negative and positive part, never confuse them. Red to positive, black to negative.
Step 3:
1.Switch the breaker on. You can use the DC output power. Any DC 12V less than 24W loading is
acceptable.
2.Switch the small switch of the AC (part No. 2), You will get 120V AC 60Hz 300W pure sine wave
power from the USA sockets.
Remarks: The two sockets share the rating output power of 300W. Please make sure the AC loading is
less than the rating output power, if the loads are motor or some complex loading, the load power should
be reduced.
This host has anti-discharging function( prevent battery from discharging to solar panel), make sure the
solar panel is always connected with the machine to assure the battery can get more power. If you use
the battery for a long period. It would cause the battery to low voltage condition (load indicator off, no
load output. The battery voltage displays 11V or below. please use the solar panel to charge the battery
for 10 continuous hours.
Step 4:
We have fully considered on the using condition of the users. The cables' length for solar panels are
long enough, so please do not lengthen them or cut them at random. But if you do have to change them
by yourself. Please make sure the size of the cable connection solar panel is not less than 1.5MM².
Tabla de contenido
