Craftmade Enduro END52 Guia De Instalacion página 5

5. Fan Assembly (with downrod).
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 4in.
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the 4in. downrod,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from motor housing
yoke. Slide downrod through canopy and
weatherproof yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
Thread downrod into the motor yoke until holes for
pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip. Tighten yoke set screws and nut
securely. Lower weatherproof yoke cover to motor
housing.
Remove electrical tape from electrical wiring and
thread one wire through each hole in the
weatherproof hanging ball cover. Pull weatherproof
hanging ball cover down securely over hanging ball
(on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
electrical wiring
hanging
ball
weatherproof
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
B
weatherproof hanging
ball cover
downrod
canopy
yoke set screw
pin
motor
housing