Troubleshooting Guide; Supplied Accessories - Sylvania SRT2313 Manual Del Usuario

OPERATIONS (Continued)
3) Use the number buttons
to enter 4-digit access
ACCESS CODE
code. The default
_ _ _ _
access code is 0000. If
you have not set up
your personal access
code, you should use 0000.
4) Press the CH(annel) ▲
or ▼ button to point to
B TV RATING
"TV RATING". MPAA RATING
CHANGE CODE
Then, press the
VOL(ume) ▲ button.
5) Press the CH(annel) ▲
or ▼ button to point to
B TV-Y
TV-Y7( ) [VIEW]
your desired item.
TV-G
TV-PG( ) [VIEW]
Then, press the
TV-14( )
VOL(ume) ▲ button to
TV-MA( ) [VIEW]
select [BLOCK] or
[VIEW].
<Selection> <Rating Category
Explanations>
• TV-Y: Appropriate for all children
• TV-Y7: Appropriate for children seven and
older
• TV-G: General Audience
• TV-PG: Parental Guidance suggested.
• TV-14: Unsuitable for children under 14
• TV-MA: Mature audience only
When you select the rating category and turn
●
it [BLOCK], the higher rating will turn
[BLOCK] automatically. Also, the lower rat-
ing will turn [VIEW] automatically.
When you turn "TV-Y" to [BLOCK] or
●
[VIEW], then all ratings will turn to
[BLOCK] or [VIEW] automatically.
When you turn "TV-MA" to [VIEW], then
●
all ratings will turn to [VIEW] automatical-
ly.
6) Press the MENU button to exit the menu

TROUBLESHOOTING GUIDE

Sometimes a performance problem can be easily solved by checking seemingly apparent but often over-
looked possibilities. Before arranging for service, check these items. It could save you time and money.
QUICK SERVICE CHECK LIST
POSSIBLE REMEDY
Try a new channel, if OK, then possible station trouble.
Is TV plugged in?
Power at outlet?
Is TV's POWER button on?
Is antenna connected to terminal on the back of the set?
If outside antenna is being used, check for broken wire.
Check for local interference.
Turn off with POWER button and then turn it on after about a minute.
Adjust COLOR control.
Adjust CONTRAST & BRIGHT control.
Check batteries in Remote Control.
Move the TV away from the nearby appliances which have Magnetism.
Unplug the TV power cord, then plug it in again 30 minutes or so later.
Closed Caption Problem
My TV is showing captions that are
misspelled.
My TV will not show the text in its entirety
or there is a delay of what is being said.
My captions are scrambled with white
boxes on the TV screen.
My program guide listed a TV show as
being closed captioned
but none of the captions were displayed.
My prerecorded videotape does not show
any captions. The tape box mentions it
being closed captioned.
My TV screen shows a black box on certain
channels.
[V-CHIP SET UP SUB RATINGS]
When you select TV-Y7, TV-PG, TV-14, or
TV-MA and you press the VOL(ume) ▲ but-
ton, the sub-ratings will appear on the TV
screen.
If you select the rating category (example: TV-
PG) and turn it [BLOCK] or [VIEW], the sub-
ratings (example: V for Violence) will turn
[BLOCK] or [VIEW] automatically.
You can set the sub-ratings to [BLOCK] or
[VIEW] individually when the rating category
is set to [BLOCK]. To set the sub-ratings indi-
vidually, follow the steps below.
When you select [TV-Y7]:
●
[VIEW]
Press the CH(annel) ▲
or ▼ button to select
[VIEW]
"FV" (Fantasy
[VIEW]
Violence). Then, press
the VOL(ume) ▲ but-
ton to select [BLOCK]
or [VIEW].
When you select [TV-PG], [TV-14] or
●
[TV-MA]:
Press the CH(annel) ▲
or ▼ button to select
"D" (Suggestive
Dialog), "L"(Coarse
Language), "S"(Sexual
Situation), or "V" (Violence). Then, press
the VOL(ume) ▲ button to select [BLOCK]
or [VIEW].
Note: When you select [TV-MA], "D" does
not appear on the TV screen.
The sub-ratings which set to [BLOCK]
●
appear next to the rating category in the TV
RATING menu.
Possible Remedy
You are watching a live broadcast and spelling errors made by the
closed captioning production company may pass through uncorrect-
ed. A prerecorded program will not show any misspelled words
because of the normal time available for editing the captions.
Captions that are delayed a few seconds behind the actual dialogue
are common for live broadcasts. Most captioning production compa-
nies can display a dialogue to a maximum of 220 words per minute.
If a dialogue exceeds that rate, selective editing is used to insure that
the captions remain up-to-date with the current TV screen dialogue.
Interference caused by building, power lines, thunderstorms, etc.
may cause scrambled or incomplete captions to appear.
Broadcasters may at times use a time compression process to the
actual program so that additional advertising time can be given.
Since the decoder cannot read the compressed information, captions
will be lost.
The videotape was either an illegal copying or the tape duplicating
company accidentally left out the captioning signals during the
copying process.
You are in the TEXT mode. Select CAPTION mode or CAPTION
[OFF].
[V-CHIP ACCESS CODE]
To change access code, follow steps.
1) Press the MENU button, then press the
CH(annel) ▲ or ▼ but-
ton to select V-CHIP
SET UP. Press the
VOL(ume) ▲ button to
continue.
2) Press the number but-
tons to enter your old
access code. If you
have never set up your
personal access code,
use 0000.
3) Press the CH(annel) ▲
or ▼ button to select
TV-Y7 [BLOCK]
CHANGE CODE.
FV [BLOCK]
Then, press the
VOL(ume) ▲ button to
continue.
4) Use the number buttons to enter your
desired access code in the NEW CODE
TV-PG [BLOCK]
space. Then, enter the same code in the
D [BLOCK] CONFIRM CODE
L [BLOCK]
space. Your new access
S [BLOCK]
V [BLOCK] code is set. You will
return to the "V-CHIP
SET UP".
If the code in the CONFIRM CODE space
does not match the code in the NEW CODE
space, repeat step 4, making sure you enter the
same new code exactly in the CONFIRM
CODE space.
TV-Y [VIEW]
TV-Y7 ( ) [VIEW]
TV-G [BLOCK]
TV-PG (DLSV) [BLOCK]
TV-14 (DLSV) [BLOCK]
TV-MA ( LSV) [BLOCK]
MAINTENANCE
CABINET CLEANING
Wipe the front panel and other exterior sur-
●
faces of the TV with a soft cloth immersed
in lukewarm water and wrung dry.
Never use a solvent or alcohol. Do not spray
●
insecticide liquid near the TV. Such chemi-
cals may cause damage and discoloration to
the exposed surfaces.
PICTURE TUBE CLEANING
Wipe the picture tube of the TV with a soft
cloth. Before cleaning the picture tube, discon-
nect the power cord.
SPECIFICATIONS
GENERAL SPECIFICATIONS
Television system:
Closed Caption
System:
Channel coverage
VHF:
UHF:
CATV:
Tuning System
Channel access:
Terminals
Antenna input:
Video input:
Audio input:
Earphone:
ELECTRICAL SPECIFICATIONS
Sound output:
NOTES:
• If a power failure occurs, the default code,
0000, will be the active access code again.
• If you connect the power cord to an AC out-
PICTURE
let that is controlled by a wall switch, your
CHANNEL SET
[ENGLISH] ESPAÑOL personal access code will be erased every
B V-CHIP SET UP
time you turn off the power at the wall
CAPTION [OFF]
switch. The default code will be the active
code again.
[IF YOU FORGET YOUR ACCESS CODE]
ACCESS CODE
You should restore the access code to default
_ _ _ _
code, 0000. To restore 0000 as your personal
access code, unplug the TV's power cord for
10 seconds, then plug it in again.
TV RATING
MPAA RATING
B CHANGE CODE
NEW CODE
_ _ _ _
CONFIRM CODE
_ _ _ _
SUPPLIED
ACCESSORIES
Remote control unit
(N0138UD or N0139UD)
Batteries ("AA" x 2)
Rod Antenna
[13" model only]
(0EMN00673 or
0EMN01599)
Owner's Manual
OTHER SPECIFICATIONS
NTSC-M Remote control:
TV Standard
§15.119/FCC Operating
temperature:
2 ~ 13
14 ~ 69 Power requirements: AC120V, 60Hz
2 ~ 13, A ~ W,
[ 13" model ]
W+1 ~ W+84,
Power consumption
A-5 ~ A-1, 5A (Maximum):
Picture tube:
181 channel
Dimensions:
frequency synthesized
tuning system
Direct access keyboard,
Weight:
programmable
[ 19" model ]
scan and up/down
Power consumption
(Maximum):
VHF/UHF/CATV
Picture tube:
75 ohm unbalanced
Dimensions:
(F-type)
RCA connector x 1
Weight:
RCA connector x 1
1/8" monaural (3.5mm)
•Designs and specifications are subject to
change without notice and without our
1W, 8 ohm legal obligation.
•If there is a discrepancy between languages,
the default language will be English.
Owner's
Manual
Digital encoded
infrared light system
5°C to 40°C
(41°F~104°F)
53W
13"
H : 12-3/4"(323mm)
W: 14-1/8"(358mm)
D : 14-4/9"(367mm)
19.0 lbs. (8.5kg)
72W
19"
H : 16-3/4"(428mm)
W: 18-3/4"(475mm)
D : 18" (454mm)
37.5 lbs. (17kg)