Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2610067378 05-21 GSB18V-535C.qxp_GSB18V-535C 5/19/21 1:37 PM Page 13
GCY42 Connectivity module
installation (sold separately)
To reduce the risk of injury
read
instructions included with Bosch GCY42
connectivity module. Operating instructions for
GCY42 connectivity module include important
information not covered in this manual.
Only use Button/coin cell 3V
lithium CR2032 battery. Do
not use any other button/coin cells or other
forms of electrical power supply.
replacement is carried out
properly. There is a risk of explosion.
Chemical Burn Hazard. Keep
batteries
children. This product contains a lithium
button/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or enters
the body, it can cause severe internal burns and
can lead to death in as little as 2 hours. If you
think a battery might have been swallowed or
placed inside any part of the body, seek
immediate medical attention.
Always completely secure
the connectivity module
compartment. If the connectivity module
compartment does not close securely, stop using
the product, remove the battery, and keep it
away from children.
When discarding batteries,
insulate the '+' and '–'
terminals with insulating tape. When disposed
of improperly, lithium batteries may short,
causing them to become hot, burst or ignite.
batteries in a fire or expose
to high heat. The batteries may explode.
Assembly
the
operating
Ensure
that
battery
away
Never
dispose
of
SAVE THESE INSTRUCTIONS
If GCY42 connectivity module is not purchased
with the tool, or if the replacement of the
from
module or the battery becomes necessary,
please follow this procedure (See Fig. 7):
- Using a flat screwdriver or a coin, remove the
cover 1 from the side of the handle, by
turning it 1/4 turn counter-clockwise.
- If the tool is already equipped with the
connectivity module, remove the battery 2,
but do not remove the connectivity module 3.
- If the connectivity module is installed for the
first time, remove the plastic placeholder 4
from the connectivity module compartment,
and place the connectivity module 3 in the
compartment observing correct orientation.
Note: Store the placeholder 4 in a safe place.
Reinsert the placeholder again if the
communications module is removed.
- Next place new battery 2 on the top of the
connectivity module with the "+" polarity
facing up.
the
- Place the cover 1 over the battery and turn it
¼-turn clockwise to lock using a flat
screwdriver or a coin.
FIG. 7
1
2
3
4
13
Tabla de contenido
