Techincal Data - Yamato TPR 500/13 K Manual De Instrucciones

Cod 98872 - mod. TPR500/13 K
1.EQUIPMENT
1 pc. Impact drill
1 pc. handle and rule
1 pc. Instruction manual

2.TECHINCAL DATA

Model
Code
Tension
Protection
Power
Reversing operation
Chuck
Drilling capacity steel/wood/masonry
B.P.M.
vibration: weighted acceleration m/s
sound power level dB (A).
Noise/Vibration Information
Measured values determined according to EN 60745.
Uncertainty K=3 dB.
Wear hearing protection!
The typically weighted acceleration is on the above table.
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test given in EN 60745 and may be used to
compare one tool with another. The vibration emission level will vary because of
the ways in which a power tool can be used and may increase above the level
given in this information sheet.
Note: To be accurate, an estimation of the level of exposure to vibration
experienced during a given period of work should also take into account the
times when the tool is switched off and when it is running but not actually doing
the job. This may significantly reduce the exposure level over the total working
period.
Intended Use
The machine is intended for impact drilling in brick, concrete and stone as well as
for drilling in wood, metal and plastic. Machines with electronic control and
right/left rotation are also suitable for screwdriving and thread-cutting.
When using electric tools it is imperative to take the following basic safety
precautions in order to reduce the risk of electric shock, injury and fire. Read and
take note of these instructions before you use this tool.
3. GENERAL SAFETY REGULATION
Read this manual carefully before operation to avoid the hazards such as
electric shock, burn of fire.
✓ The work area must be kept clean to avoid danger.
TPR500/13 K
98872
500W
II
0-2.900
SI
<1,5 13 mm.
10-25-13
0-40500
. K=1,5 8,12
2
86
8