Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Selecting the Spray Setting
Fig. A = vertical flat jet
Fig. B = horizontal flat jet
Fig. C = circular jet
Fig. D = Wrong settings.
WARNING! Danger of injury! Never pull the trigger guard while adjusting the air
cap.
a)
b)
12.
-
+
3. Spray Technique
●
The spray result depends heavily on the smoothness and cleanliness of the surface to be sprayed.
Therefore the surface should be carefully prepared and kept free of dust.
● Cover all surfaces not to be sprayed.
● Cover screw threads or similar parts of the target object.
● It is advisable to test the spray gun on cardboard or a similar surface to find the correct setting.
Important: Begin spraying outside of the target area and avoid interruptions inside the target area.
P-6
for vertical surfaces
for horizontal surfaces
for corners, edges and hard-to-reach surface.
Adjusting the Material Volume
Set the material volume by turning the
regulator on the rear part of the spray gun. A
scale on the regulator serves as a guide:
+ turn to the right ➟ higher material volume
-
Attention:
Only one direction is applicable when
changing setting.
cause damage!
a) Change
horizontal
Vertical. Counter clockwise rotate
the changing button 90°.
b) Change
vertical
horizontal. Clockwise rotate the
changing button 90°.
The changing button can only be
rotate at one direction.
turn to the left ➟ lower material volume
Do not force or will
flat
jet
to
flat
jet
to
Tabla de contenido
