Tabla de contenido
Idiomas disponibles
Idiomas disponibles
and Health
Act (OSHA). These standards, particularly part 1910 of the General Standards and part 1926 of the
Construction
Standards should be consulted.
• Use only manufacturer authorized parts. User assumes all risks and liabilities when using parts that do
not meet the minimum specifications and safety devices of the turbine manufacturer.
• Do not spray outdoors on windy days.
• Wear protective clothing to keep paint off skin and hair.
• Never aim spray gun at any part of the body.
Household Use Only
CAUTION To reduce the risk of electric shock, do not expose to rain. Store indoors.
WARNING
Risk of Explosion – Do not spray flammable liquids
SERVICING OF A DOUBLE-INSULATED PRODUCT
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means is provided
on a double-insulated product, nor should a means for grounding be added to the product. Servicing of a double-insulated
product requires extreme care and knowledge of the system, and should be done only by qualified service personnel.
Replacement parts for a double-insulated product must be identical to those parts in the product.
DISCONNECT FORM SUPPLY CIRCUIT BEFORE OPENING.
DO NOT USE BELOW GARAGE FLOOR OR GRADE LEVEL.
WARNING: WHEN A COMBUSTIBLE LIQUID IS SPRAYED THERE MAY BE DANGER OF FIRE OR
EXPLOSION, ESPECIALLY IN A CLOSED AREA. READ INSTRUCTION MANUAL BEFORE
OPERATING.
WARNING: DO NOT SPRAY ELECTRICAL APPARATUS AND WIRING.
DO NOT IMMERSE IN WATER OR SOLVENT.
Coating Materials Suitable for Use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
Coating Materials Not Suitable for Use
Wall paints (emulsion paints) etc., alkali and acidic paints.
Preparing the Coating Material
The paints usually need to be diluted for use with the spray gun. Since information on
sprayable dilutions is seldom given on the material tin, you can use the guidelines in the
viscosity table on the following page (viscosity = consistency of the coating material).
Measuring the Viscosity
1. Stir the coating material thoroughly before measuring.
2. Dip the viscosity test cup completely into the coating material.
3. Hold the test cup up and measure the time in seconds until the liquid empties out.
P-3
Tabla de contenido
